In the current industrial production and processing industry, cutting fluid has been widely used, but processing different materials also has different requirements for cutting fluid, so we have to choose a suitable cutting fluid for processing. When cutting fluid is used and transported, if we do not store or use it properly, it is prone to deterioration and corrosion. Once the cutting fluid is deteriorated and corroded, it will cause a decrease in output rate, and it may also cause more serious problems. Economic losses. The editor of Qiantian has compiled the following points for you to understand why the cutting fluid deteriorates and corrodes? 1. Chemical reagents of relatively poor quality may be added to the cutting fluid, which is relatively corrosive, which indirectly increases the corrosiveness of the cutting fluid; 2. It may be that the quality of the cutting fluid itself is relatively low, so its · synthesis The material is relatively corrosive, which will cause the cutting fluid itself to be corrosive, which will corrode the tool and skin during use; 3. It may be that the pH value of the cutting fluid is too high or too low, and the pH value will affect the acidity of the cutting fluid. Alkaline value, whether the cutting fluid is too acid or too alkaline, will increase the corrosiveness of the cutting fluid. What can be done to better prevent the cutting fluid from being corroded? 1. Regularly strengthen the maintenance and supervision and management of cutting fluid; 2. When preparing cutting fluid with water, try to avoid using hard water to prepare; 3. The humidity of the working environment should be within a suitable range to prevent contamination of the cutting fluid and affecting the use; 4. Strengthen the environmental sanitation of the production workshop and do not allow the cutting fluid to Contaminant exposure. Strengthen the operation of workers and the training of the use of cutting fluid; 5. The newly purchased cutting fluid should be used in accordance with the guidance of the cutting fluid manufacturer, and the PH value and concentration value of the cutting fluid should be monitored regularly to prevent the concentration value of the cutting fluid and the concentration value of the cutting fluid. The PH value is too high or too low, causing the metal cutting fluid to be corroded. The above is an introduction to the corrosion of cutting fluid and the solution, organized and shared by the editor of the microemulsion cutting fluid manufacturer Qiantian. I hope that the introduction of this article can help everyone.
Post time: Jun-30-2021